Non-asbestos organic (NAO) brake pads are made from organic materials

Non-asbestos organic (NAO) brake pads are made from organic materials like rubber, glass, fiber, high temperature resins, and even Kevlar. They are softer than brake pads that partially consist of metal and because of that they make a lot less noise and are easier on the rotors.The material consists of brass wire inserted yarns containing a mixture of organic and inorganic fibers, including Kevlar. The woven tape is vacuum impregnated for thorough saturation with an oleoresinous compound. Long slow curing, with alternate rolling and compressing, and a final high temperature step cure, bonds the material into an extremely dense and strong product with excellent friction and wear characteristics.
Surfaces are ground to +0.005" of normal thickness. It is best used for band brakes and bank clutch service, both wet or dry. Also general use where a high friction lining is required. High quality lining made of special non asbestos heat-resistant tightly woven fabric,brass wire reinforced, impregnated with oiş-resistant, wear-proof and heat resistant synthetic resin, finished to prescribed size of roll, generally from 4.8 to 25.4 mm thick, 25,4 mm to 300 mm width and 50 feet long.Environmentally friendly and high temperature resistance.The brake lining is made using premium materials for excellent braking performance.The friction material brake lining, apply for commercial vehicles. Low density, noiseless, excellent wear resistance and heat resisitance.Hurtless to corresponding drum, 100% non-asbestos, you will find it sensitive and safe while braking. We can design and produce brake lining according to customer's requirements.Processing methods: Hot-press, heat-treatment, drill, grind, dust-clear.Product is 100% asbestos-free making it safe for environmentally friendly operation,Produces minimal dust and helps prolong rotor life,Built to withstand even the harshest operating conditions.All Haldex brake linings are designed for trouble-free repair and maintenance.Brake pads and other brake components are essential safety devices for stopping moving vehicles.
Brake components made with asbestos are still widely available on foreign, aftermarket products.They feature such superior qualities as low wear and low abrasion and excellent fade resistance, and are suitable for a variety of functions, from industrial rotating equipment to tensioning devices. High quality lining made of special non asbestos heat-resistant tightly woven fabric,brass wire reinforced, impregnated with oiş-resistant, wear-proof and heat resistant synthetic resin, finished to prescribed size of roll, generally from 4.8 to 25.4 mm thick, 25,4 mm to 300 mm width and 50 feet long.Asbestos-free brake pads and brake pads do not contain any asbestos components.Asbestos-free and low-metal automobile brake pads are uniformly pressed and formed by mixing resin binder, steel fiber, non-asbestos fiber, barium sulfate, friction powder, stabilizing curing agent, friction increasing agent, antifriction agent, and copper fiber. Compared with existing technologies, it has the advantages of no noise, no environmental pollution, and good wear resistance.